ACI

ACI A/1K-NI-SP Sensor 1000 Ohm>/h1> ACI A/1K-NI-SP Features Two wire 25 second nominal response time Technical Literature Link:ACI Sensor

ACI A/3K-BP Temperature Sensor 3K ACI A/3K-BP Features: Two(Non-Polarity Sensitive Wires) 10 second Response Time Technical Literature: Bullet Probe Data

ACI ACI/CP-S-GD Strap On Sensor 10K Non-intrusive strap-on thermistor sensor with a copper plate for strong thermal contact with pipes when immersion isn’t possible. It uses double...

ACI AFP Analog Input Controller The AFP allows an analog signal to control a floating point actuator. It converts an analog signal into two relay contact outputs (one increase/one decrease). The...

ACI ACI/AFS-460 Pressure Differential Switch ACI AFS-460 Air Differential Switch Manual Reset 0.4 to 12 WC ACI ASF-460 Features SDPT N/C -40 to 180 F (-40 to 82 C) Operating Temperature Range .5 PSI...

ACI ARM2 Analog Input Controller Input to Dual 4-20 Output Technical Literature:ACI ARM2 Datasheet ACI ARM2 Installation & Operation Instructions

ACI ATL Analog Input ACI ATL Features: Each relay has an adjustable trip point which is set by a multi-turn trimmer potentionmeter. Accept a resistance input by using voltage divider...

ACI CO-D Duct CO Transmitter 0-10 VDC Output Industrial carbon monoxide detector for use as continuous monitor. ACI CO-D Features: Supply Voltage - 24V AC/DC Transmitter Range - 0 to 200ppm Response...

ACI CO-R Room CO Transmitter Industrial carbon monoxide detector for use as continuous monitor. ACI CO-R Features: Supply Voltage - 24VAC of 24VDC Transmitter Range - 0 to 200ppm Response Time -...

ACI CO-R-RB-D Room CO Detector with Display and Buzzer Industrial carbon monoxide detectors with display and warning buzzer. ACI CO-R-RB-D Features: Supply Voltage - 24VAC of 24VDC Transmitter Range...

ACI DRN3.1.0-135 Advanced Control Analog Voltage Purchase includes two components: 1. PWM/Analog/Floating Point Input (Signal Converter) 2. Resistor Card (0 to 135 Ohms) Technical Literature: ACI...

ACI EFP2G A.C.T. Floating Point to Pneumatic The EFP converts a floating-point signal into a proportional pneumatic signal ranging from 0-20psig. It is designed with electrical terminals on one end...